In PrusaSlicer you can find the firmware retraction setting in the “General -> Advanced” section. Marlin then does a retraction and optional Z-hop.įirst you need to configure your slicer to emit firmware retraction commands. The slicer enters gcode G10 any time a retraction is needed and gcode G11 at the end of the travel move. Retractions can sometimes be burned away - but they will always leave some marks on a print Enter firmware retractionįirmware retraction allows you to control any retraction parameters during a print. Retraction tuning can drive you crazy and needs a lot of manual slicer work if you want to try multiple parameters. You may find you need to adjust multiple parameters to prevent oozing: This causes the classic “lightning” arcs you see in a stringing test.ĭifferent filaments have different retraction behaviors. The worst thing is that stringing can cause more stringing, because when the nozzle hits stringing on the next layer more filament is pulled out. If retraction is not sufficient (assuming the filament is decent), then you “bridge” a small amount of filament across the travel move. Generally a retraction is done before a travel move. The retraction reduces pressure in the nozzle. Tuning retractions while a print is running with Community Firmware release 6Ī retraction during 3D printing is the act of pulling back filament in order to prevent oozing of filament out of the nozzle. In this article I show you how to use it! Marlin supports adjusting retractions while a print is running - when you have “firmware retraction” enabled. You can also use it save a print that experiences too much stringing. The ability to adjust retractions during a print is invaluable when tuning in new filaments.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |